Baroness LM66GC, Owner'S Operating Manual, Page: 47 / 85

Issue 1:
The cutting height fluctuates due to the up-
and-down movements of the mower caused
by the weight of the grass catcher.
Solution:
The mower and grass catcher operate
independently.
Therefore, the mowing attitude of the
mower is not affected, even when the
grass catcher becomes heavier from the
added weight of grass, thatch, sand, etc.
The operator can mow at a uniform cutting
height from the start of mowing the green
to the end.
1 3
2
4fx8ud-002
IGCA (Independent Grass Catcher Arm)_002
1 IGCA
2 Mower
3 Grass catcher
Issue 2:
The cutting height is uneven due to the up-
and-down movements of the mower caused
by the operator's handle movements.
Solution:
The grass catcher and handle are linked,
eliminating as much as possible the
transfer of rough handle movements
causing changes in the mower's attitude.
By adjusting the link rods, the handle can
remain centered in the handle adjuster,
and uniform mower contact pressure can
be achieved.
4
3
4
6
1
2
5
4fx8ud-003
IGCA (Independent Grass Catcher Arm)_003
1 IGCA
2 Mower
3 Grass catcher
4 Handle
5 Link rod
6 Handle adjuster
Effect 1:
Regardless of skill level, any operator can
mow at a uniform cutting height, as long as
the handle can be adjusted within the range
of the hole in the handle adjuster.
This is effective when accelerating very
quickly or mowing undulations.
3 1 2
4fx8ud-004
IGCA (Independent Grass Catcher Arm)_004
1 IGCA
2 Mower
3 Grass catcher
Handling Instructions
LM56GC
・
LM66GC / LM66TC
Handling Instructions
Page 4-25
Operation of Each Section