Baroness LM315GC, Owner'S Operating Manual, Page: 42 / 86

Adjust the front roller up and down by the
roller adjuster to determine the position of
the front roller, in order not to have a gap
with the neck position of the cutting height
screw of the cutting height gauge, at the
edge of the bed knife.
3
4
2
1
3kws2a-007
Adjustment of Front Roller_002
1 Bed knife (bottom blade)
2 Cutting height screw
3 Cutting height gauge
4 Cutting height
Repeat the same process at the opposite
side for the adjustment of cutting height.
Tighten the nuts that secure the right and
left roller brackets to secure them firmly.
Again, make sure that the cutting height is
at the required position by applying the
cutting height gauge to the front and rear
rollers at each edge of right and left of the
mower unit.
Adjustment of Groomer
Caution
For adjustment, be sure to use the cutting
height gauge so that the right and left
sides can be parallel.
Otherwise it may cause damage on the
bearings.
Set the grooming height more than 0.0 mm
from the ground.
Otherwise it may cause damage on the
groomer shaft, bearings and gears etc.
When using the grooming brush, set it to
the same height as the cutting height.
If it is set lower, it may wear easily.
4.
5.
6.
7.
･
･
･
Set the groomer screw of the cutting height
gauge to the desired height.
5
1
3
4
2
2qrq2r-002
Adjustment of Groomer_001
1 Front groomer
2 Groomer screw
3 Cutting height gauge
4 Grooming height
5 Front roller
Loosen the nuts fixing the right and left
groomer adjustment bolts.
1
2
3
2qrq2r-001
Adjustment of Groomer_002
1 Groomer adjustment bolt
2 Nut
3 Groomer adjuster
1.
2.
LM315GC
Handling Instructions
Page 4-18
Adjustment Before Operating