Baroness LM101, Owner'S Operating Manual, Page: 67 / 88

Connect the lapping machine or the lapping
handle to the lapping bolt on the machine.
1
zhz6po-010
Back Lapping_005
1 Lapping machine
Rotate the reel cutter (cutting cylinder)
clockwise (when you face the mower frame
from the left).
Turn on the lapping machine.
Or rotate the lapping handle.
Important
The right side of the reel cutter (when you
face the mower unit from the front) is inclined
to wear earlier than the left side. Accordingly
be sure to move the brush from the left to the
right to apply the abrasive.
zhz6po-012
Back Lapping_006
Apply the abrasive evenly with the brush on
the top side of reel cutter (cutting cylinder)
where the newspaper was cut well or of
chalk-marked locations.
(Never apply to blunt areas.)
Rotate the reel cutter for a while and stop its
rotation when the sound of contact is lost.
Turn off the lapping machine.
Or stop rotating the lapping handle.
Disconnect the lapping machine or the
lapping handle (accessory tool).
9.
10.
･
11.
12.
･
13.
Wash off or wipe off with a cloth, etc., the
abrasive from the reel cutter (cutting
cylinder), and then check it for sharpness.
Repeat steps 5 to 13 until the entire range
(three or four points) of the reel cutter
(cutting cylinder) is uniformly sharpened.
Finally, apply abrasive to the entire blade
width of the reel cutter (cutting cylinder) and
perform final back lapping.
Important
Pay attention not to pour water over the
engine and electric components when
cleaning.
Wash out the abrasive with a washer etc.
While checking the blade for sharpness,
adjust blade engagement.
14.
15.
16.
17.
18.
Maintenance
LM101
Maintenance
Page 5-15
Maintenance Work