Baroness GM2810, Service Manual

Page: 143 / 185

In order to avoid damage to the shaft when
removing it, use an iron pipe, etc., and tap
the pipe with a plastic hammer.
1
2
3
1lbr3a-005
Inspection of Housing_005
1 Shaft
2 Iron pipe
3 Plastic hammer
Place the housing upside down and remove
the stop ring.
1
2
2ljrxq-001
Inspection of Housing_006
1 Housing
2 Stop ring
Important
Be careful not to hit the rubber part since the
bearing may be damaged.
With the housing turned upside down,
follow the steps below to remove the
bearing.
Place blocks of wood, etc., under the
housing to create space for the bearing
to be pushed out.
6.
7.
8.
[1]
Use an iron pipe and tap it with a plastic
hammer to remove the bearing.
1
2
3
4
1lbr3a-006
Inspection of Housing_007
1 Bearing
2 Housing
3 Iron pipe
4 Plastic hammer
Place the housing right-side up, and then
use an iron pipe and tap it with a plastic
hammer to remove the bearing and oil seal.
1
2
3
4
5
1lbr3a-007
Inspection of Housing_008
1 Housing
2 Bearing
3 Oil seal
4 Iron pipe
5 Plastic hammer
[2]
9.
Operating Machine and Mower Units
GM2810
Operating Machine and Mower Units
Page 7-25
Inspection and repair of each section