Baroness GM2810, Service Manual

Page: 142 / 185

Housing
Inspection of Housing
Bearing wear due to frequent usage or
bearing damage caused by water infiltration
may prevent the rotary knife from rotating
smoothly. Inspect and replace parts such as
oil seals and bearings.
Make sure that the housing does not have
any chips or cracks.
Make sure that there is no wear or damage
of the shaft.
Make sure that there is no wear or damage
of the oil seal.
Make sure that there is no wear or rusting
of the bearing.
Make sure that there is no play in the fit of
the shaft and the bearing.
Danger Danger
The rotary knife is an edged tool.
Handle it carefully, since it could cut your
hands or legs.
Caution
Wear gloves when touching edged tools to
avoid cutting your hands.
Remove the mower unit. (See "Removal of
Mower Unit" (Page 7-5) .)
Remove the two bolts used to install the
stopper, and then remove the stopper.
1
2
1lbr3a-001
Inspection of Housing_001
1 Stopper
2 Bolt
･
･
･
･
･
1.
2.
Remove the four bolts used to install the
housing.
1
2
2
1lbr3a-002
Inspection of Housing_002
1 Housing
2 Bolt
Pull up the housing to remove it.
1
1lbr3a-003
Inspection of Housing_003
1 Housing
Remove the roundhead screw and washer
used to install the stop ring, and then
remove the stop ring.
1
2
3
1lbr3a-004
Inspection of Housing_004
1 Stop ring
2 Roundhead screw
3 Washer
3.
4.
5.
GM2810
Operating Machine and Mower Units
Page 7-24
Inspection and repair of each section