Barnett Engineering B1277, Installation & Operation Manual, Page: 11 / 50

INSTALLATION PAGE 7
Wiring Your Outputs
Refer to Figure 2 for details of output pinouts
Figure 2 Output Connections
The four output relays can be programmed for either remote control or to
indicate internal status of the Cv3. Internal status can be programmed as
‘new alarm present’, ‘any alarm present’, a pulsed output when an
acknowledgement is received or as a system alarm. When used for status
indicators, specific relays are assigned as follows:
•
Relay 1 New Alarm
•
Relay 2 Any Alarm
•
Relay 3 Acknowledge Received
•
Relay 4 System Error
Two contacts from each relay are brought to the terminal block. The idle
state of the contacts (either normally open or normally closed) is set in
programming.