BARKO LOADERS 295, Service Manual

Page: 20 / 85

page 20
295 AC
800-00158
Hydraulic Reservoir - Replace oil and clean
suction screens.
Entire Loader - Steam clean, inspect for
stress, wear, cracks, damage, and loose parts.
SERVICE REQUIRED
NOTE: Use the intervals on Service Schedule when operating in normal conditions. Service the
machine at shorter intervals when operating in very hot, cold, dusty, or humid conditions.
SERVICE SCHEDULE CONTINUED...
Pilot Filters in Valve Banks - Remove, inspect
and clean.
Air Conditioner Air Intake Filter - Replace.
8 hours
Daily
50 hours
Weekly
100 hours
Monthly
400 hours
2 Months
1000 hours
6 Months
Yearly
Swing Motor Gearbox - Replace fluid. On new
machines the fluid should be changed first at 50
hrs. and then every 400 hours thereafter.
Tires - Check for correct pressure.
Axle Cradle Center Pivots - Lubricate.
Articulating Pivot Points - Lubricate.
Pump Drive - Replace fluid.
Planetary Axle - Drain and fill with lubricant.
Replace seals. Refer to Service Manual.
Drive Shaft Universal Joint - Lubricate.
Brakes - Adjust if necessary.
Wheel Bearings - Clean and inspect. Replace
if necessary. Pack with grease.
Hydraulic Oil Filter - Replace elements every
400 hours, after initial change at 50 hours on a
new machine.
Transmission - Check fluid. Add if necessary.
Transmission - Change fluid (80-90 gear fluid).
Visually inspect the tires for proper inflation, and for cuts, gouges, blisters or tread separation.
Check the tire pressure. Make sure all tires are properly inflated.
WARNING
Improperly inflated tires can cause excessive heat buildup resulting in blowouts. Always
keep tires inflated to the proper pressure. Unexpected blowouts may cause severe injury or
death.
CAUTION
Over or under inflated tires can cause a drastic reduction in tire and rim life.
CAUTION
Keep the valve caps on to prevent dirt from entering the valves. Dirt will cause valve damage.
TIRES