Barko Hydraulics Barko Loaders 160B, Service Manual

Page: 130 / 146

page 130 page 130 page 130 page 130 page 130
160B&C TM
800-00140
DON'T DON'T
DON'T DON'T
DON'T
REMOVE REMOVE REMOVE REMOVE REMOVE
ELEMENT FOR ELEMENT FOR ELEMENT FOR ELEMENT FOR ELEMENT FOR
INPECTION
INPECTION
INPECTION INPECTION
INPECTION
Such a check will always do more harm to your
engine than good. Ridges of dirt on the gasket sealing
surface can drop on the clean filter side when the
gasket is released. Stick with the schedule. If you
are on restriction maintenance, follow your reading or
get a new indicator if you don't trust it.
NEVER NEVER
NEVER NEVER
NEVER
RAP AN RAP AN RAP AN RAP AN RAP AN
ELEMENT TO CLEAN ELEMENT TO CLEAN
ELEMENT TO CLEAN ELEMENT TO CLEAN ELEMENT TO CLEAN
IT. THIS WILL ONLY
IT. THIS WILL ONLY IT. THIS WILL ONLY IT. THIS WILL ONLY IT. THIS WILL ONLY
DESTROY IT.
DESTROY IT.
DESTROY IT. DESTROY IT. DESTROY IT.
Rapping hard enough to knock off dust often damages
the element and destroys your engine protection.
Deeply embedded dirt is never released by tapping.
It's always safer to keep operating until you can
change to a fresh filter.
NEVER NEVER
NEVER NEVER
NEVER
JUDGE JUDGE JUDGE JUDGE JUDGE
YOUR ELEMENT'S YOUR ELEMENT'S YOUR ELEMENT'S YOUR ELEMENT'S YOUR ELEMENT'S
LIFE BY LOOKING
LIFE BY LOOKING
LIFE BY LOOKING LIFE BY LOOKING
LIFE BY LOOKING
AT IT.
AT IT.
AT IT. AT IT. AT IT.
A dirty filter may still have plenty of life left, while
carbon contamination is not visible to the eye. And
you can't see the dirt that is embedded deep within
the filter paper. Your best bet for lowest filter
maintenance costs and best engine performance is to
follow a restriction gauge. It's a smart, low-cost
investment.
NEVER NEVER
NEVER NEVER NEVER
LEAVE AN LEAVE AN
LEAVE AN LEAVE AN
LEAVE AN
AIR CLEANER OPEN AIR CLEANER OPEN AIR CLEANER OPEN AIR CLEANER OPEN AIR CLEANER OPEN
LONGER THAN
LONGER THAN
LONGER THAN LONGER THAN LONGER THAN
NECESSARY.
NECESSARY. NECESSARY. NECESSARY. NECESSARY.
Your open air cleaner is a direct entry to your engine.
If the element is not going to be changed and
reassembled immediately, cover the opening. The
only way to be sure nothing got in is to be sure
nothing gets in.
THE IMPORTANT "DON'TS" TO ALWAYS REMEMBER: THE IMPORTANT "DON'TS" TO ALWAYS REMEMBER:
THE IMPORTANT "DON'TS" TO ALWAYS REMEMBER: THE IMPORTANT "DON'TS" TO ALWAYS REMEMBER:
THE IMPORTANT "DON'TS" TO ALWAYS REMEMBER:
DON'T DON'T
DON'T DON'T
DON'T
OVERLOOK A OVERLOOK A OVERLOOK A OVERLOOK A OVERLOOK A
WORN OR
WORN OR
WORN OR WORN OR
WORN OR
DAMAGED GASKET
DAMAGED GASKET
DAMAGED GASKET DAMAGED GASKET DAMAGED GASKET
IN THE HOUSING
IN THE HOUSING IN THE HOUSING IN THE HOUSING IN THE HOUSING
If your cleaner has a cover gasket, replace it with a
new one. Always check to be sure no piece of the
old gasket remains in the housing and that the gasket
is not worn. If your filter model calls for a new gasket
with each use, never reuse the old one.
DON'T DON'T DON'T DON'T DON'T
USE A USE A
USE A USE A USE A
DENTED OR DENTED OR
DENTED OR DENTED OR
DENTED OR
BUNCHED FILTER
BUNCHED FILTER BUNCHED FILTER BUNCHED FILTER BUNCHED FILTER
ELEMENT.
ELEMENT.
ELEMENT. ELEMENT.
ELEMENT.
Never install a dented or punctured element, because
it cannot protect properly against contamination. A
dent can make a firm seal impossible or can indicate
damaged media. An element with bunched pleats
saps engine power and fuel dollars right from the
start.
NEVER NEVER
NEVER NEVER
NEVER
USE A USE A USE A USE A USE A
WARPED COVER WARPED COVER
WARPED COVER WARPED COVER WARPED COVER
ON A HOUSING
ON A HOUSING ON A HOUSING ON A HOUSING ON A HOUSING
Replace with a new cover as soon as possible. A
warped or damaged cover cannot make a proper seal.
Also check to make sure there is no damage to the
air cleaner housing that could cause a leak.
NEVER NEVER NEVER NEVER NEVER
SUBSTITIUTE AN SUBSTITIUTE AN
SUBSTITIUTE AN SUBSTITIUTE AN
SUBSTITIUTE AN
INCORRECT
INCORRECT INCORRECT INCORRECT INCORRECT
ELEMENT MODEL
ELEMENT MODEL
ELEMENT MODEL ELEMENT MODEL
ELEMENT MODEL
NUMBER
NUMBER
NUMBER NUMBER NUMBER
Elements may look almost identical but can differ by
a fraction of an inch in length - a difference that
makes a firm seal impossible. You're always better
off using the dirty element until you can get the
correct model.
AIR CLEANER MAINTENANCE CONTINUED... AIR CLEANER MAINTENANCE CONTINUED...
AIR CLEANER MAINTENANCE CONTINUED... AIR CLEANER MAINTENANCE CONTINUED...
AIR CLEANER MAINTENANCE CONTINUED...