Barco Thor Series, Installation Manual, Page: 120 / 182

R5906788-03 Thor series 120
F
FOCUS
Image 11-18
5. Is it possible to focus the center of the projected image using the motorized focus control (Local Keypad) ?
Ensure that the lens is zoomed for maximum image on the screen (
WIDE ).
► If yes, nominal position is good for sharp focus in the middle of the projected image. Proceed with step 6.
► If no, obtain the best possible focus in the center of the projected image using the motorized focus control
and then turn the three Scheimpflug adjustment nuts, reference 1, 2 and 3 Image 11-19, equally in or out until
the center of the projected image is sharp.
Attention: Keep in mind the turning direction of the Scheimpflug
adjustment nuts for further adjustment instructions in this procedure.
F
1
2
3
Image 11-19
6. Zoom the lens for minimum image on the screen ( TELE ) and focus the center of the projected image using the
motorized focus control (Local Keypad).
F
FOCUS
Image 11-20
7. Is it possible to focus the center of the projected image using the motorized focus control (Local Keypad) ?
Ensure that the lens is zoomed for minimum image on the screen (
TELE ).
► If yes, no further adjustment actions required. Proceed with step 8.
► If no, obtain the best possible focus in the center of the projected image using the motorized focus control
and then turn the three Scheimpflug adjustment nuts, reference 1, 2 and 3 Image 11-21, equally in or out until
the center of the projected image is sharp.
Note : the same turning direction as in step 4 is applicable.
Scheimpflug