BARCO 36
Daylight Display Systems
Tile Accessing
What has to be
done
To access the Wall Tiles after they have been installed can be realized in three possible
ways. Either:- Front Access, Back Access or Hot Swap possibilities.
Necessary Tools
Front Access tool. M10 Wrench (for hot swap).
For safety reasons, it is
not
recommended to use any other parts than those specified.
Back Access
For removing a tile by accessing it from the back, follow the next procedure:
Front Access
For removing a tile by accessing it from the front, follow the next procedure:
Hot Swap
It is also possible to change a tile without interrupting the performance of the display,
from the front or rear, follow the next procedure:
1
2
Remove the connection module on the back of the tile
without disconnecting the power- and data cables (you can
access the tile from the front as well as from the back as
described above). This can be realized by unscrewing it
and disconnecting the inside power and data cable.
Now you can install another tile by placing this connection
module into it and placing the tile into the Assembly again.
Step
Action
Image
continued on next page
1
2
2
Put the Front Accessing Tools into the little holes in the
sides of the tile. Vertically in the middle of the right and left
sides of the module. Pushing and turning in this tool will
also detach both spring latches of the tile. Pull the tile
gently forwards to detach from the display.
From here its possible to remove the tile by pulling it out of
the assembly (of course after disconnection of the power
and data cables).
Step
Action
Image
1
2
1
Safely disconnect the power and data cables to the tile.
Push both spring latches of the tile to the middle. Hold tile
securely. Push the tile a little forwards and lay it flat on both
arms.
Rotate tile diagonally 45
0
s. Remove tile by pulling out of
the assembly from the back.
Step
Action
Image
Summary of Contents for R9850010
Page 4: ......