BARCO 20
Daylight Display Systems
Assembly Connection
(Continued)
For safety reasons, it is
not
recommended to use any other parts than those specified.
Connecting Left
& Top
Connecting other Assembly-connections (like Assembly 2-2)
, follow the next
procedure:
To be continued on next page.
1
2
3
4
5
Example
& 4
4
4
Here two sides of the Assembly have to be removed, the
left side and the bottom side (2-2).
Follow the previous procedure for removing the left side
frame.
Follow the previous procedure for removing the bottom
side frame.
An extra difficulty exists in that it is impossible to place the
Assembly against both other joining Assemblies. Therefore
a shift of the aluminum corners on one side (left or bottom)
of the Assembly will be required.
For Assembly 2-2, the aluminum corners on the left side of
the Assembly are shifted about three centimeters to the
right (the same for all corners on that side).
After connection of the bottom-side you can replace the
corners on the left side to their original position. Then fix
them to the other Assembly using hammer bolts. Here its
important to place the caliper in the holes on the
connection of the four Assemblies to prevent displacement.
Put at least two calibers in the holes on the connection of
the two Assemblies to make sure that there isnt any
displacement of the Assemblies. After fixture, they can be
removed and used to align other assemblies.
Step
Action
Image
Summary of Contents for R9850010
Page 4: ......