1-2
Unpacking and Dimensions
5975128 BARCODATA 8200 221297
310a.DRW
Battery installation in the RCU.
A battery (not yet installed to save the battery life time) is delivered inside the plastic bag with the power
cord. To install the battery, remove the battery cover on the backside of the remote control by pushing
the indicated handle a little to the bottom of the RCU. Lift up the top side of the cover at the same time
(fig. 1).
Insert the new 9 V battery (type E-block or equivalent) in the lower compartment and connect the battery
to the contact plate.
Insert the battery into the lower compartment and put the cover back.
Note : projector address has to be programmed on the RCU before using the RCU (see chapter
'Controlling').
fig.1
fig.2
Insert here the 'Insert card
RCU' which you can cut out
on the last page of this manual.
Contact
plate
Battery
Summary of Contents for R9001250
Page 1: ...OWNER S MANUAL R9001250 DATA 8200...
Page 2: ...BARCO PROJECTION SYSTEMS Date 030798 OWNER S MANUAL Rev 03 Art No R5975128 R9001250 DATA 8200...
Page 13: ...Installation Set Up 4 2 5975128 BARCODATA 8200 221297...
Page 25: ...7 2 Start up of the Adjustment Mode 5975128 BARCODATA 8200 221297...