Barco Loki, Installation Manual

Page: 108 / 128

601 – 0445 /05 Loki 108
9.1 Communication
About
System settings / Communication
Network connection is required to communicate with the projector via LAN or Internet.
Current Ethernet communication information is given, and can be edited in this menu.
Default mode for Ethernet communications are: Automatic ON / IP Version 4 DHCP mode.
Setting Description
Automatic
ON DHCP enabled
OFF Static
IP version 4
Static mode Set address, subnet mask and default gateway according to network
specification.
DHCP mode Assigned IP address, subnet mask and gateway.
Image 9-1
Manually set up the IP adress
Go to the menu System settings / Communication / LAN
Enable the Auto zone on the display and press enter. The Auto zone will change to “ Manual ” .
Scroll down, and modify the desired fields. When in the desired fields, press “ Enter ” to enable the virtual
keyboard, enter the desired values, and press “ Enter ” again to confirm the change.
9.2 Apply a menu theme
About
System settings / Themes
Themes are used to apply a predefined functionality to the OSD display. There are two options: light (default)
or dark. (From software version 1.5, the
“ Dark ” theme is the default.)
It is the “ Light ” option that is shown in the menu screenshots in this manual, as this gives a better rendering.
9.3 Standby ECO
About Standby ECO
When the ECO mode is enabled, the projector will automatically go to ECO standby mode after a time-out
(default 15 minutes). All electronics (including fans, pumps, ...) go down except for a very small wake-up
controller. See section dedicated to the Power Mode transitions for further details.
System settings menu