Barco Hydra Compact, User Manual

Page: 44 / 74

4. Operating
Barco – Hydra Compact – R5976568 – Revision 10 – February-2004
____________________________________________________________________________________________
4-2
4.1 BIOS setup
The BIOS of the single board computer (SBC) gets pre-configured at the factory. If there is anyhow the need to
access the BIOS settings some hardware configuration must be done to be able to enter the BIOS.
4.1.1 Entering the BIOS
To access the BIOS, the SBC must be connected to a monitor and a keyboard, therefore follow the steps below:
•
Halt the H
YDRA
C
OMPACT
. When the H
YDRA
C
OMPACT
has halted, switch it off by the power switch [5] on the front ] on the front
of it, see section 3.3.3 Switching off .
•
Connect a monitor to the VGA connector [2] of the single board computer and a PS/2 keyboard to the PS/2
keyboard connector [6] of the single board computer, see section 3.2.2 Single board computer .
•
Switch on the H
YDRA
C
OMPACT
by pressing the power switch [5] of the H
YDRA
C
OMPACT
again.
•
Keep the DEL key of the keyboard pressed until the BIOS setup has started. If the DEL key was pressed to
late and the possibility to enter the setup has passed, restart the H
YDRA
C
OMPACT
with the key combination
CTRL ALT DEL RL ALT DEL .
4.1.2 BIOS settings
The table below lists the H
YDRA
C
OMPACT
specific BIOS settings that must be selected for proper operation:
path setting
Inside Utilities -> Display Setup -> Embedded VGA/LCD/TV
Type CRT1 + LCD
Inside Utilities -> Display Setup -> Set Panel Type Panel Type 1280x1024
TFT Color
IBM
ITSX94
Table 4-1
BIOS settings of H
YDRA
C
OMPACT
Take care not to use the entry »default settings« as this applies other settings than fault settings« as this applies other settings than
mentioned above. Nevertheless if so, please readjust the BIOS to the above Hydra Compact
settings!
4.1.3 Finishing the BIOS changes
•
If you made necessary changes to the BIOS, safe them. Exit the BIOS.
•
Halt the H
YDRA
C
OMPACT
and switch it off again, please see above.
•
Now you can safely disconnect monitor and keyboard from the SBC.
•
The H
YDRA
C
OMPACT
can be taken into its usual operation again.