Barco HDF W series, Use And Installation Manual

Page: 41 / 319

3. Physical installation
X mm
Image 3-39
Turn the projector upside down and slide the rigging points on there place in the slots, according the measured distance and secure
this position. To release the nuts of the rigging points use a 24 mm open ended spanner. Ensure that the rigging points are
symmetrically lined up, so that the projector will hang in balance.
Warning: Be careful while working with heavy loads.
Warning: Always secure the rigging points after adjustment.
X mm
N
Image 3-40
Rigging points, distance
Turn in the rigging clamps (A) into the rigging points using a 17 mm open ended spanner and secure the rigging clamps by turning
the safety nut (B) on the rigging clamp against the rigging point using a 17 mm open ended spanner.
Warning: Always use four (4) rigging points, equally spread, to suspend the projector.
A
B
B
Image 3-41
Mounting clamps
Place all four rigging clamps in open position as illustrated.
R5905158 HDF SERIES 16/06/2015 37