Barco HDF W series, Use And Installation Manual

Page: 39 / 319

3. Physical installation
1/3 to 1/2
Image 3-35
Fasten lock nut d.
Tighten nut 4 until the offset of the image movement created in step 3 is canceled.
Tip: The amount of image movement in step 3 will determine how tight the nut in step 5 will need to be turned to return the
image to its original position.
3.3 Power connection
C
AUTION
:
Use only the power cord provided with the projector.
How to connect your projector with the local power net ?
Ensure that the power switch (S) stands in the “0” (OFF) position.
Connect the power cord (P) with the power input socket of the projector as illustrated below.
Secure the power plug by locking the plug holder clamp (H).
Connect the other end of the power cord with the local power net.
Caution: Ensure that the power net meets the power requirements of the projector.
The voltmeter (M) will immediately indicate the value of the mains voltage as soon as the projector is connected with the power
net.
1
2
M
S
H
P
P
M
S
H
Image 3-36
Power connection
Fuses
The projector is protected with an automatic circuit breaker of 35 A which is built in into the power switch.
R5905158 HDF SERIES 16/06/2015 35