Barco F90 series, Service Manual

Page: 7 / 141

1. Introduction
1. INTRODUCTION
Overview
• Scope and limitations
• Copyright
• Trademarks
• Required Handtools
1.1 Scope and limitations
Scope
This document is intended to describe fault resolution, low frequency maintenance and parts replacement procedures for the Barco
F90. Only partners named in service agreement with Barco Fredrikstad AS may carry out procedures detailed in this document. In-
formation contained herein is subject to change without further notice; please refer to online documentation for updated information.
1.2 Copyright
Copyright
All rights reserved. No part of this document may be copied, reproduced or translated. It shall not otherwise be recorded, transmitted
or stored in a retrieval system without prior written consent of Barco.
1.3 Trademarks
Trademarks
Brands and product names mentioned in this manual may be trademarks, registered trademarks or copyrights of their respective
holders. All brands and product names mentioned in this manual serve as comments or examples and are not to be understood as
advertising for the product or their manufacturers.
1.4 Required Handtools
Required Handtools
The following tools are needed for servicing the unit:
• Screwdriver,s, Torx6, 8, 10, 20.
• Allen Key, Size 1.5, 2, 3, 5mm
• Scalpel
• Screwdriver, Flat head 4mm
• Ionized pressurized air for cleaning optical components
• Adjustable thermal heater for releasing Cooling system.
• Suitable cleaner for thermal transfer compound, (Brake / clutch cleaner). Isopropanol can be used, but are not as powerful as
brake cleaner.
Unless otherwise indicated in the procedure, screw torque to be applied is 0.3 Nm.
723–0016 F90 01/12/2017 5