3. Getting started
Barco – Eos X Terminal – DOC-3061-2 – user's manual – Revision 11 – November-2004
___________________________________________________________________
3-34
3.3.2
Switching on
Switch on E
OS
by pressing the
power
button on the front!
If you have expanded your E
OS
with E
OS
E
XTENDERS
switch on these first.
There are two different boot modes for E
OS
.
Normal boot mode and eXtended safety boot mode. See section
. The operation of E
OS
differs a little, depending on this mode.
Normal boot mode
The displays show their respective bus and slot no., e. g.:
PCI Bus: 2, PORT: 1
After a few minutes the graphical user interface X.11 appears.
If software configuration has already been carried out you can go on with chapter
. Otherwise proceed
configuring E
OS
in section
eXtended safety boot mode
The displays show their respective bus and slot no., e. g.:
PCI Bus: 2, PORT: 1
The E
OS
startup screen comes up. Select
linux
to boot from the working partition.
If you select backup, the restore procedure is started and the working partition becomes
overwritten with the backup system, which might lead to a loss of current data, depending
on the state of the backup, please see section
4.8.5 Backup and restore procedures (eosxs Utility)
Figure 3-43
Eos startup screen
After a few minutes the graphical user interface X.11 appears.
If software configuration has already been carried out you can go on with chapter
. Otherwise proceed
configuring E
OS
in section
