4. Operating
Barco – Eos X Terminal – DOC-3061-2 – user's manual – Revision 11 – November-2004
___________________________________________________________________
4-22
Configuring video streams
The parameters of a video stream must be defined in the
SVC Stream Params Editor
, before the S
TREAMING
V
IDEO
C
ARD
can display it. Once defined it is available for every S
TREAMING
V
IDEO
C
ARD
in the system. To open the
SVC
Stream Params Editor
select
SVC Pref … -> Stream Settings
from the
File
menu, please refer to section
Pressing the
Add
button adds a new stream with the entered name into the
Streams
list. The parameters that
are displayed at that time are saved together with it. If there exists already an entry with the same name then
its parameters are not changed. Pressing the
Apply
button applies the displayed parameters to the hardware. In
that way changes can be controlled directly. Pressing the
OK
button applies the parameters to the hardware and
to the system. Pressing the
Cancel
button closes the window, anyhow changes that are already confirmed with
the
Add
or
Delete
button can not be revoked.
Stream
A list of all video streams in alphabetic order
Decoder Control
IP Address
select the type of stream (
unicast
,
broadcast
or
multicast
)
when
multicast
is selected also the multicast IP address must be specified
Port
Encoder port, appendant to the IP address.
IP Portocol
Selection of the used IP protocol.
(firmware < 2.0 of the S
TREAMING
V
IDEO
C
ARD
only supports
UDP
)
Stream Protocol
auto
Auto-detection of the stream protocol
elementary
Elementary stream
program
Program stream
transport
Transport stream
PID
Should be entered for transport streams when the PAT (program allocation tables) or
PMT (program map tables) are not sent.
0
is a predefined value. It causes an auto-search for the video PID. If no valid PID is found
no video will be shown.
Skip bytes at …
Start
End
Encoder dependant value of the number of bytes that must be skipped at the beginning
/ end of each packet, please see table below.
