4. Operating
Barco – Eos X Terminal – DOC-3061-2 – user's manual – Revision 11 – November-2004
___________________________________________________________________
4-25
Input Settings
Auto
Auto adjustment of source
Sync Level
Determine the sync level of the signal
HV:
tuning the horizontal/vertical sync level
SoG:
tuning the Sync on Green level
Position
Position display area of visible RGB signal in the Canvas Panel
H:
horizontal position of first active pixel (in steps of two)
V:
vertical position of first active line
Size
Determine size of visible RGB signal
H:
number of active pixels per line (in steps of four)
V:
number of active lines
Phase
Tune phase shift of ADC
PLL Devider
Determine pixel frequency of RGB input
Info
Information about input signal
V_Tot: number of lines
V_Freq: frame rate
Sync: mode of synchronization
Registry
Clear Name
Clear text box, which displays name of current preset
Append
Current setting is added to the list of presets
Insert
Current setting is inserted in the list of presets (before the highlighted preset)
Replace
Replace highlighted preset by current setting
Delete
Delete highlighted preset
Clear all
Delete all listed presets
Save
Save all listed presets in preset file
Reload
Reload preset file and discard changes
Import
Add
Add all highlighted presets to list of presets
Clear Select
Clear selection
Dismiss
Dismiss dialog box
Figure 4-10
If the applied signal changes while
adjusting the settings, then a warning
message apears, please see below. You
can change to the contol tab and select an
appropriate timing for the new signal
(click YES).
It is also possible, that the system detects a new timing, if the settings have been displaced
too much. In this case click NO and readjust the settings again.
