4. Operating
Barco – Eos X Terminal – DOC-3061-2 – user's manual – Revision 11 – November-2004
___________________________________________________________________
4-23
Encoder Control
This section contains data that is used, if initial communication with the encoder is
needed to prompt the encoder to send a stream. All fields must be filled in!
IP Address
IP address of the encoder; may only be filled in if
TCP
has been selected for
IP Protocol
Port
Port where the encoder listens to TCP start commands; may only be filled in if
TCP
has
been selected for
IP Protocol
IP Protocol
Should remain
udp
, as indicated in the section
Decoder control
above. Only if a commu-
nication with the encoder is required,
tcp
should be selected.
Startstring
String that is sent to the specified encoder
Figure 4-8
Parameters on the SVC Stream Params Editor
As unicast streams are only sent to one single IP address, only one Streaming Video Card at
a time is able to display one particular unicast stream.
The following table lists the encoder specific values that must be entered into the
SVC Stream Params Editor
.
Encoder
IP Protocol
Skip bytes
at Start …
Skip bytes
at End …
Stream type
TCP
PID
VCS VideoJet 1000
firmware
<
2.0
UDP
16
0
auto
Off
0
Display stamping (including Time, Stamping, Time Stamping, … ) is used
firmware
≥
2.0
RTP
4
0
auto
Off
0
Display stamping (including Time, Stamping, Time Stamping, … ) may not be used
Vbrick 4000
UDP
0
0
auto
Off
0
The encoder setting Low Latency should not be used; if there are big changes in the video image
a green flash will appear at the bottom side of the video.
IMPath I-Volution
4000
UDP
0
0
auto
Off
0
NKFC-20
firmware
<
2.0
UDP
28
0
auto
Off
256
firmware
≥
2.0
RTP
0
0
auto
Off
256
Visiowave
firmware
≥
2.0
UDP
0
0
auto
ON
0
Use »visiowave« as startstring and specify also the other entries in the section Encoder Control!
Table 4-7
Encoder dependant parameter values
