Barco DP2K-12C, Service Manual

Page: 161 / 359

8. Light processor assembly
1
Image 8-25
Notch
fi lter, adjustment button
2. Start up the projector and display an uncorrected red test pattern.
Tip: See user guide of the Communicator software for detail instructions about color calibration
3. Measure the X and Y values of the projected red test pattern. Use for that a colorimeter. Make sure that the red test pattern is
uncorrected.
4. Slightly move the adjustment button up or down until the measured X and Y values are within the required specs. (See above)
Note: The adjustment range of the notch fi lter is limited. For most projectors the mid position gives also the most optimal result.
5. Fasten the thumb screw again (reference 1), to secure the position of the notch fi lter. Make sure that the position of the notch
fi lter remains unchanged while fastening the thumb screw.
R5905043 DP2K-12C/11CX 19/02/2018 157