29
Infrared Burner (for STS3211ALP/NG &
STS3211BLP/NG Models) and Rotisserie
Burner Electrode Check
10
Push and turn Infrared Burner Control Knob &
Rotisserie Burner Control Knob to . Look for
spark between electrode tip and spark receiver
tip.
If you don't see a spark from Infrared Burner
Electrode or Rotisserie Burner Electrode, adjust
gap between electrode tip and spark receiver
tip to 3/16 inch wide.
AA Battery may be installed backwards.
Electric wires may be loose. Remove the AA
Battery and inspect the Ignitor Junction Box
found behind the Control Panel and recon-
nect any loose wires.
-
-
Install Cooking Components
11
Place the Flame Tamer Rack inside the Grill Bowl.
Position it onto the lower ledge of the Bowl above
the burners. Next, place the Flame Tamers on the
Flame Tamer Rack. (See the diagrams on right)
Place the Cooking Grids on the ledge above the
Flame Tamers.
Place the Secondary Cooking Rack into the slots
on Grill Bowl Side Panels.
Main Burner Electrode Check
With the assistance of another person,
perform this Electrode Check before
proceeding.
9
Be sure all Control Knobs are set to "OFF" and
open the Grill Lid.
Have your assistant stand behind to the right of
the grill and look toward the front of the grill bowl.
Never
put your face inside the Grill Head.
Push and turn Burner Control Knob to and
you will hear a "clicking" sound as the burner
is being ignited. Your assistant should see a
blue spark within each Gas Collector Box. If
a spark is present the Electrode Tips are
properly positioned.
If no spark is seen, the Spark Gap needs to be
adjusted as follows:
This test will ensure that the Spark Electrode Tips
are properly positioned so your grill lights easily
and properly.
•
•
If the gap between the Spark Electrode Tip
and Receiver is more than 3/16" wide use
needle nose pliers to gently squeeze the
Gas Collector Box to narrow gap.
Recheck the Electrode again, if no "clicking"
sound is heard:
Spark Electrode Tip
Spark Receiver
Spark Gap 3/16"
Gas Collector
Box
(for STS2611ALP/NG &
STS2611BLP/NG Models)
(for STS3211ALP/NG &
STS3211BLP/NG Models)
Final Grill Assembly Step
When you have finished assembling your grill,
be sure that all screws are tightened for safe
operation of your grill.
Before each use of the grill, make sure the
Grease Tray is fully seated under the Grill Bowl.
CAUTION: The Grease Tray should be inspected
before each grill use to be sure there is no ex-
cessive grease buildup. Clean the Grease Tray
frequently to eliminate grease build-up and to
prevent grease fires.
Cooking Rack/Secondary
Cooking Grids
Flame Tamer/
Ceramic, Front
Flame Tamer Rack
NOTE: These steps apply for all the STS models.
Cooking Rack/Secondary
Cooking Grids
Flame Tamer/
Ceramic, Front
Flame Tamer Rack
Upside of the Flame
Tamer, Ceramic/Front
Upside of the Flame
Tamer, Ceramic/Front
