USE AND CARE INSTRUCTIONS
32
Note: The built-in appliance for use with a remote self-con-
tained LP Gas supply system must use rigid pipe. semi-
rigid tubing or a connector complying with the Standard for
Connections for Gas Appliance, ZNSI Z21.24/CSA 6.10
One Nut is fixed to Tank Holder.
An additional Nut and Wing Bolt
is secured AFTER inserting tank
into tank hole.
Wing Bolt 1/4"x1/2"
Qty. 1
Part # S233G04084
(Already installed on the Tank Holder)
LP Gas Model only:
Secure a 20lb LP Gas Tank to Gas Grill
The Wing Bolt is used
to secure the Tank
Foot.
Additional Nut
Tank Holder
Tank Tray
Secure a 20lb LP Gas Tank to Gas Grill
(for STS2611BLP & STS3211BLP)
Note:
You can only use a 20lb LP Gas Tank in this
Gas Grill.
NOTE:
When using Propane, EXTREME CAUTION
should be used to provide ample ventilation of vapor
from the enclosure. LP Gas vapor is heavier than air
and SERIOUS INJURY from a DANGEROUS EXPLO-
SION could occur if LP Gas is allowed to accumulate
in an enclosure and then ignited. Both the Barbecue
enclosure and LP cylinder enclo- sure require venting
that must be provided at the floor level of the enclo-
sure to allow any leaking LP Gas vapor to escape
(see Fig. 1).
NOTE:
When installing a barbecue equipped for liquid
propane in an island, the propane tank must be in
a separate enclosure that is completely isolated from
the barbecue. It must be cross-ventilated in accor-
dance with the current standards. The propane tank
MUST NEVER be installed directly under the barbe-
cue.
NOTE: Upper & lower ventilation openings (20 sq. in
and 10 sq. in minimum each) MUST BE PROVIDED
on both sides of built-in construction. Upper ventila-
tion opening located within 5" under the top of the
enclosure. Lower ventilation opening located with Its
bottom edges shall be 1" or less and top edges not
more than 5" above the island bottom. Every opening
shall have a minimum dimension 1/8" (See Fig. 4 on
page 27).
Turn your LP Gas Tank Valve clockwise to the
closed or OFF positon.
Open the door and unscrew the Wing Bolt from right
bracket of tank holder.
Place LP Gas tank into tank holder. Be sure bottom
of tank fully rests in cutout in bottom shelf.
Install the tank so the Tank Valve faces the rear
Left corner of cabinet.
Align and screw the Wing Bolt into right bracket of
tank holder to secure the gas tank.
Attach the Regulator with Hose to the gas tank.
Fig. 1
Non-Combustible
Construction, such as
stone, marble, cement
Air Vents
Partition Panel
Stainless Steel Tube (Refer
to the Note below).
5/8" UNF
Thread
