4
Install NG Regulator and 12 Foot Hose
Install the NG Regulator onto the Regulator Bracket using 2 Phillips Head Screws 3/16"x1/4".
Connect NG Gas Fitting with Hose to the Gas Manifold. Install the NG Regulator Bracket to your
Rear Island Panel using 3 Phillips Head Screws 3/16" x 1/2" and tighten using 3 Flange Nuts 3/
16" as shown.
Connect the Swivel Nut of the 12 foot Hose to the NG Gas Regulator.
26
Install the Transformer. Connect the Transformer to Power Source and turn on the Grill Lights.
(for STS3211BLP/NG Models)
3
Swivel Nut
Vertical Fitting
Gas Manifold
12' Natural
Gas Hose
Phillips Head Screw
3/16"x1/2"
Qty. 3
Part # S112G0308E
Flange Nut 3/16"
Qty. 3
Part # S313G03051
Fig. 1
Wire
Transformer-socket
Transformer-plug
AC-plug
Fig. 2
An island is shown for illustrative
purposes in the diagram.
Phillips Head Screw
3/16"x1/2"
Qty. 4
Part # S112G0308E
Hex Nut 3/16"
Qty. 4
Part # S362G0306E
Make a hole on
your Rear Island
Panel to pull the
cord out
Remove Transformer from box (the transformer is in Grill Head).
Install Transformer-Plug into Transformer-Socket and tighten securely. (See Fig. 1)
Install Transformer to the Rear Island Panel* by using 4 Phillips Head Screws 3/16"x1/2". Secure and
tighten using 4 Hex Nuts 3/16". (See Fig. 2).
Pull the Transformer Cord out through the hole on the Rear Island Panel*. Make sure the cord doesn't
touch the ground.
Rear Island Panel* is not included with the purchase of Grill Head. Depending on your island construction,
you may need to make 5 holes on your Rear Island Panel before installing the Transformer.
Plug Transformer Cord into a properly grounded outlet.
After installing the transformer, plug the transformer into the power source. Push the Light Switch on the
Control Panel to turn on the lights.
Phillips Head Screw
3/16"x1/4"
Qty. 2
Part # S112G0304E
