Barbeques Galore BEEFMASTER G2BV, Instructions For Assembly And Use

Page: 29 / 69

Page 29
Before proceeding, it is important that you leak test the barbeque. Make sure all the
barbeque control knobs are OFF, If you have a portable gas cylinder, turn the gas cylinder
ON by rotating the control valve handle anti-clockwise. If you have a wall connection, ensure
the bayonet fitting is connected and the stop valve opened.
Spray or pour soapy water (about the same concentration as washing up water) along the
gas line including:
• The gas connection at the inlet of the barbeque.
•
The gas hose or copper piping, including any joints or bends in the piping
•
The gas connection at the gas cylinder or the wall connection.
• If bubbles appear, there is a gas leak. If the leak is at a connection, tighten and retest. If
the leak is anywhere else, or if you cannot resolve the leak, do not proceed.
•
If you have a portable gas cylinder, turn the gas cylinder OFF and consult your retailer.
• If you have a bayonet connection, remove the hose from the wall fitting and consult your
retailer.
•
NEVER use a flame to test for leaks.
With a portable gas cylinder, you can also check for leaks more easily and more thoroughly
using a gas safety gauge, available at your Barbeques Galore store. Pressure the system,
close the cylinder valve and check that the needle reading does not fall which indicates a
gas leak.
If a gas leak is found, turn OFF the gas supply and barbeque control valves. DO NOT use
the bbq until the leak is resolved. Check again for leaks periodically and whenever a refilled
or swapped gas cylinder is fitted.
Safety leak testing