18
4
Install the Side Burner Lid Chain (for B3812ALP/NG Models)
Wire
Transformer-socket
Transformer-plug
AC-plug
Fig. 2
5
Install the Transformer. Connect Transformer to Power Source and turn on the Lights.
Pan Head Screw
3/16"x3/8"
Qty. 3
Part# S182G03061
Install Tank Tray Set (for B3812ALP & BAI12ALP Models)
6
Install the Tank Tray Set onto the Cart Bottom Panel using 3 Phillips Head Screws 3/16"x3/8" as
shown in Fig. 3.
Place the LP Gas Tank into the Tank Tray Set so that the tank valve faces the right corner.
Install LP Regulator onto the Gas Tank.
Remove the pre-assembled Phillips Head Screw 1/4"x1/2"
from the Rear Panel of the Bowl Frame as shown. Reserve
this screw for later step.
Install the Side Burner Lid Chain onto the Rear Bowl Panel
using the reserved Phillips Head Screw 1/4"x1/2" from the
previous step.
Phillips Head Screw 1/4"x1/2"
Qty. 1
Part # S112G04081
Already installed in the Rear Panel of the
Bowl Frame
Open the Left Door Panel, locate the 4 key holes on the rear side of Left Cart Side Panel/Trim Plate
as shown.
Attach the Transformer to the Left Cart Side Panel/Trim Plate by inserting the two stud bolts on the
transformer bracket into the two key holes on the side panel as shown. Press the Transformer downward
until it rests in place. (See Fig. 1).
Insert Transformer-Plug into Transformer-Socket and tighten securely. (See Fig. 2)
Pull out the Transformer Cord from the hole on the Cart Rear Panel. (See Fig. 3)
Connect the Transformer power supply cord plug into a properly grounded 120VAC outlet.
Turn on the Grill Lights by pushing the Left Light Switch on the Control Panel.
Turn on the Control Knob Seat LED Lights by pushing the Right LED Switch on the Control Panel.
Fig. 3
Note:
The Transformer can
be attached to the top two
holes or the lower two holes.
Fig. 1
L eft Cart Sid e
Panel/Trim Plate
Note:
Make sure the
plug does not touch
the ground.
