21
4
Install NG Regulator and 12 Foot Hose (for B3812BNG & BAI12BNG models)
Install the NG Regulator to the Manifold Extension Fitting and tighten securely.
Connect the Swivel Nut of the 12 foot Hose to the NG Regulator.
Fig. 3
Island Bottom
Panel
Tank Tray Set
Pan Head Screw
3/16"x3/8"
Qty. 5
Part# S182G03061
Manifold Exten-
sion Fitting
Swivel Nut
Not provided
WHEN YOU FINISHED THIS STEP, PLEASE SKIP TO STEP 7.
NOTE: Make sure the 12 ft. NG hose stays away from sharp edges.
Install Regulator, Tank Tray Set and Liquid Propane(LP) Gas Tank
(for B3812BLP &
BAI12BLP Models)
5
5/8" UNF male
thread
stainless steel flexible connec-
tor
(Not provided) must compy with the
Standard for connectors for Outdoor Gas
Appliances and Manufactured Homes,
ANSI Z21.75
•
CSA 6.27, and suitable for
outside installation.
The maximum length of the connection
shall be 6ft.(1.82m).
Note: Regarding the connector, for safety, we suggest use a stainless steel flexible connector. But, if using
semi-rigid tubing, do not use materials made of aluminum or aluminum alloy tubing. The connector should
be installed at the location visible when opening the door.
On the proper location, drill 2 holes on the island left side panel for installing the regulator bracket. Then
install the regulator using 2 Pan Head Screws 3/16"x3/8" and tighten securely.
On the proper location, drill 3 holes on the island left bottom panel for installing the tank tray set. Then
install tank tray set using 3 Pan Head Screws 3/16"x3/8" and tighten securely.
Connect the stainless steel flexible connector to the manifold and regulator, then use a clamp to hold
the stainless steel flexible connector as shown for securing.
Place the LP gas tank into the tank tray set. Make sure the tank valve facing the right rear corner of
left island. Tighten the wing bolt to secure the LP gas tank. (
See Fig.3
)
Connect the LP regulator onto the LP gas tank.
CAUTION:
There shall be a minimum clearance of 2 inches (50.8 mm) between the floor of the LP-gas cylinder
enclosure and the ground.
