barbas 70-55 PF2, Installation And Maintenance Manual

Page: 45 / 84

5.3 Prepare the appliance for use
• Do all the procedures in this section. Optional procedures are indicated with
(optional).
5.3.1 Do a check on the overpressure hatches
1. Make sure that the overpressure hatches are loose. Push the overpressure hatches
up and lower them back in position.
2. Do a check on the gasket of the overpressure hatches. The gasket must seal the
opening.
3. If necessary, replace the gasket. Lift the hatch and twist it to remove the hatch and to
get access to the gasket.
5.3.2 Do a check on the operation of the lighting
• Make sure that the operation of the ambient lights functions well. To operate the
lights with the remote control, refer to the user manual
5.3.3 Put the ceramic logs on the burners
Refer to chapter
2.5
for an overview of the wood logs and their numbers.
Caution: Handle the ceramic logs with care.
1. Make sure all items of the ceramic log set are there. Refer to chapter 2.5 .
2. Remove the 2 screws that hold the two front burners on the gas supply line.
Figure 32.
3. Remove both front burners.
Figure 33.
Installation
Gas Fire Panorama 70-55 45