6
work. Park machine company, the ground.
In the sulfuric acid toxic battery electrolyte, it can burn skin and clothes of
corrosion. If splashed on your clothing or skin sulfate to rinse immediately
with plenty of water.
For battery to work to wear goggles or safety glasses, if splashed into eyes,
rinse immediately and go to a doctor.
Metal object touch the battery terminal may cause short
circuit and burn to you, tools to stay away from the battery
terminal.
Fire, lit a match and flame to stay away from the battery, battery
(hydrogen) gas explodes.
Disassembly and assembly of battery to make sure the battery
terminal (+, -) properly connected.
If the water into the electrical system, the operation will lead to
failure. Don't use water on sensors, connectors, and vehicle
instrument.
Don't deal with electrical equipment, wear wet gloves that could lead to electric shocks.
Work together with others, choose a leader and work according to his instructions. Don't to outside
any maintenance work.
Unless you have special instructions, must the ability after the motor stopped for maintenance work.
If the motor run time for maintenance, you must have two technicians present: a piling car operation,
and another for maintenance work. In this case, do not touch any contact with any moving parts.
Before adjustment, lubrication and maintenance work, close all the power switch.
Remove containing O gaskets or seal parts, clean up the installation
surface and replace the new seal.
Thoroughly clean the machine, particularly carefully clean oil components
and in the area near the oil dipstick. Be careful not to let any dirt or dust
into the system.
Can only be used to allow the burning cleaning solvent.
When change hydraulic oil or filter, check the hydraulic oil and filter for excess
metal particles or other foreign material.
Use of manufacturers to provide spare parts for replacement, make sure that
the replacement of parts or components is the same as the original parts.
Check the open gear box, there might be a material falls into. Before remove the cover for inspection,
to ensure that you have nothing in his pocket. Then carefully remove the nut.
Summary of Contents for EP16-N01
