Baoli EP16-N01, Service Maintenance Manual

Page: 29 / 67

29
33 Check electromagnetic braking air gap

34 Detection of emergency braking function

35 Detect reverse braking and regenerative braking function

36 Detection of belly switch function

37 Check the steering function

38 Check the function of lifting and lowering

39 Check the handle lever switch function

Comprehensive
40 Check whether all labeling clear full

41 Check the castor, if wear for height adjustment or replacement

42 Make a test run

LUBRICATING POINT
According to the maintenance list lubricating the marked point. Grease required specifications for: DIN
51825 standard grease.
CHECK AND REFILL THE HYDRAULIC OIL AGAIN
The hydraulic oil type required:

H-LP 46, DIN 51524

Viscosity is 41.4-47

According to the type of the oil are respectively 0, 7 L 16/20.
Waste materials such as waste oil, waste batteries or other materials must be according to the national
laws and regulations for processing and recycling, if need to pay to the recycling company for recycling.
Required to start the vehicle when the oil level should not be less than the minimum amount of oil.If it is
necessary to add oil to gas.
1. Steering bearing
2. Supporting roller bearing
3. Oil pump
4. Shaft
5. Binding point
6. Wheel load bearing
Figure. 16: lubrication points