Baoli EP16-N01, Service Maintenance Manual

Page: 4 / 67

4
1. GENERAL
1.1 INTRODUCTION
–
MAINTENANCE SAFETY PRECAUTIO
Maintenance work may cause injuries. Always take care to perform work safe, at least observing the
following. It is of utmost importance that maintenance personnel pay strict attention to these warnings
and precautions to avoid possible injury to themselves, others or damage to the equipment. A
maintenance program must be followed to ensure that the machine is safe to operate.
The specific precautions to be observed during maintenance are inserted at the appropriate point in the
manual. These precautions are, for the most parts, those that apply when servicing hydraulic and larger
truck component parts
MODIFICATION OF THE TRUCK WITHOUT CERTIFICATION BY A RESPONSIBLE
AUTHORITY THAT THE TRUCK IS AT LEAST AS SAFE AS ORIGINALLY MANUFACTURED, IS A
SAFETY VIOLATION.
SINCE THE TRUCK MANUFACTURER HAS NO
DIRECT CONTROL OVER THE FIELD INSPECTION AND
MAINTENANCE, SAFETY IN THIS AREA RESPONSIBIUTY OF THE
OWNER OR OPERATOR.
FAILURE TO COMPLY WITH SAFETY PRECAUTIONS,
LlSTED IN THIS SECTION MAY RESULT IN MACHINE DAMAGE, PERSONNEL INJURY OR DEATH
AND IS A SAFETY VIOLATION.

Only specially trained personnel to the local operation.

Please read it carefully before operation or maintenance vehicle
operation and maintenance manual.

Read all the vehicles with preventive measures.

Make sure you fully understand operation content. Maintenance vehicles
before preparing the necessary tool box parts are very important.

Maintenance vehicles is the first consideration when you and the safety
of others. In the absence of mechanical equipment parts do not move.
Please do not place heavy objects on the location of the instability. Improve equipment part; make
sure to provide enough support.

We should pay attention to the machine hydraulic system to operate
under the pressure of high risk. In any part of the disconnect or
remove system before doing everything it can to reduce the system
pressure. Through many times to stop and start the cycle control
motor, reduce the system pressure.