Banner R-GAGE Q90R, Instruction Manual

Page: 12 / 32

February 12, 2024
Q90R R-GAGE® Radar Sensor Instruction Manual
© Banner Engineering Corp. All rights reserved.
12
Output
Loss–of–Signal : Sets the Analog Output value used by the sensor during a loss of signal. When a signal is restored,
measurement resumes.
Hold Last Value—The Analog Output holds the last value indefinitely during a loss of signal.
3.5 mA (0 V)—The Analog Output switches to this value 2 seconds after a loss of signal. For Voltage models, this is 0
V. (Default)
20.5 mA (10.5 V/5 V)—The Analog Output switches to this value 2 seconds after a loss of signal. For Voltage models,
this is 10.5 V.
Averaging: Use this menu to set the number of measurements that are averaged together for the analog output.
Increasing the averaging improves repeatability but increases the total response speed. The default is 1. The filter can be
set to 1, 2, 4, 8, 16, 32, 64, or 128. The total response time is shown under Response Time.
Response Time
Calculates the total response time, taking into account the general response speed and averaging.
Response Speed
Analog Output Filter Setting
1 2 4 8 16 32 64 128
Analog Output Spec (ms)
Fast 16 32 64 128 256 512 1024 2048
Medium 80 160 320 640 1280 2560 5120 10,240
Slow 200 400 800 1600 3200 6400 1280 2560
The following are the parameters on the Discrete 1 tab on the Sensor Settings pane.
Output Mode
Select Switch Point or Window .
Switch Point : The distance at which the switch point threshold is placed.
Window : Define two set points to create window limits.
Distance Settings
Define the set point(s) and the hysteresis.
Output Settings
NO/NC : Select Normally Open or Normally Closed from the list.
On Delay : Set an on delay in milliseconds. The maximum time is 60,000 ms.
Off Delay : Set an off delay in milliseconds. The maximum time is 60,000 ms.
Response Time
Calculates the total response time, taking into account the general response speed and on or off delays.
Response Speed Discrete Output ON Spec (ms) Discrete Output OFF Spec (ms)
Fast 50 50
Medium 100 200
Slow 250 550
The following are the parameters on the Discrete 2 tab on the Sensor Settings pane. This tab is available for dual discrete
models.
Output Mode
Select Switch Point , Window , Complementary , or Pulse Pro/PFM .
Switch Point : Set a single switch point for the output to change.
Window : Define two setpoints to create window limits.
Complementary : Output 2 will be the opposite of Output 1.
Pulse Pro/PFM : Pulse Pro/PFM output to interface with Banner lights or a PLC with PFM inputs.
Analog Table 2.
Discrete 1 Tab 4.4.3
Discrete Table 3.
Discrete 2 Tab 4.4.4
FINAL DRAFT