4
Supply Power to the Q45 Sensor Pair
The Q45 Sensor Pair comes with two sensors: Sensor A and Sensor B. Sensor A has a metal connector on the bottom. Sensor B has a
six-inch cable. Complete steps 1 through 6 below for both Sensor A and Sensor B.
Set Up Your Hardware
Supply power to all devices
The Occupancy Monitoring Kit arrives with all necessary power sources needed to get the system operating quickly. This
includes lithium batteries for the Q45 Sensor Pair and Direct Select Operator Interface, and a DC power supply for the DXM
Controller and TL70 Wireless Indicator Light.
1
Supply Power to the DXM Controller
Plug the power supply into the DXM Controller, aligning the keys in the connector, and
hand tighten. Plug the power supply into a power outlet using the appropriate regional wall
adapter.
3. If the indicator LED does not automatically
begin flashing, turn on the Operator Interface
by pressing and holding
and
together
for five seconds or until the small light starts
flashing red.
4. Reassemble the Node and tighten the four
corner screws. Do not over-tighten.
5. If the indicator LEDs do not automatically begin
flashing, turn on the sensor by pressing and holding
the button for five seconds until the LED to the right
of the button flashes.
1. Loosen the clamp plate with a
small Phillips screwdriver and lift
the cover.
2. Using a small Phillips screwdriver,
insert the tip into the small hole in the
battery holder and pry up the battery
holder. Slide the battery board up and
out of the housing.
3. Insert the AA lithium batteries and verify the
positive and negative terminals of each battery
align to the positive and negative terminals.
Caution: There is risk of damage if the batteries
are installed incorrectly.
+
−
4. Slide the battery board
back into the housing.
6. Close the cover and gently tighten the clamp
plate with the small Phillips screwdriver.
Supply Power to the Direct Select Operator Interface
1. Unscrew the four corner screws with a
Phillips screwdriver and open the Operator
Interface.
2. Insert the 3.6 V lithium battery. Verify the
battery’s positive and negative terminals align
to the positive and negative terminals as
marked.
Caution: There is risk of damage if the
batteries are installed incorrectly.
Indicator LEDs
Button
Indicator LED
