Banner DXM1200-X2, Instruction Manual

Page: 37 / 83

February 02, 2024
DXM1200-X2 Controller Instruction Manual
© Banner Engineering Corp. All rights reserved.
37
Cellular modem board (optional)
U.FL antenna
connector
Chapter Contents
Cellular Modem Board for LTE ........................................................................................................................................................................... 37
Cellular Power Requirements............................................................................................................................................................................. 37
Using the DXM Cellular Modem ......................................................................................................................................................................... 37
Cellular Modem Board for LTE
The 4G LTE cellular modem is an optional accessory that is installed on the two 12-pin sockets.
Plug the cellular modem into the right socket (when
viewing the internal PCB with the connectors at the
bottom). The SIM card slides into the socket on the back
of this board.
Cellular Power
Requirements
If the incoming voltage drops below 11.2 V DC, the
cellular modem does not turn on and will not turn on until
the voltage is above 11.8 V DC.
Using the DXM Cellular
Modem
The DXM cellular modem provides a remote network
connectivity solution for the DXM Controller.
To use the cellular modem:
Activating a Cellular Modem
Follow these basic steps, as detailed in this document, to activate the cellular capabilities of your DXM Controller.
Cellular Modem Boards
Chapter 5
Verify the cellular modem is installed and the correct antenna is connected to the cellular antenna port. 1.
Activate the cellular service. 2.
Configure the DXM Controller to use the cellular network as the network interface. 3.
Purchase a cellular modem kit from Banner Engineering Corp. 1.
Install the cellular modem, connect the antenna cable, and connect the cellular antenna. 2.
Activate a cellular plan to the SIM card, then insert the SIM card into the cellular modem. 3.
Configure the DXM to use the cellular modem. 4.