Bass and treble
In the
Bass and treble
menu, decrease or increase the bass level and the treble level.
Activate loudness
The human ear is less sensitive to low frequencies when they are played at low volume
levels. In other words, when you lower the volume, the less bass you can hear. The
Loudness
function counteracts this effect. As you reduce the volume, the bass and treble
levels are automatically increased to compensate for your reduced perception in the
outer frequency bands. Loudness can be switched on or off for each sound mode.
Sound information
Look up information on the current sound system in the
Sound info
menu.
Eco mode
Make power saving settings for sound in the
Eco mode
menu. If you enable eco mode,
the speakers that do not receive a signal when the television is on automatically switch
off. Wireless speakers are not switched off when they do not receive signals from the
television.
Speaker connections
Wired speakers
When setting up wired speakers, you must select which speakers you have connected to
each Power Link (PL) socket in the
Speaker connections
menu.*
*If all Power Link sockets with connected speakers are not shown in the
Speaker
connections
menu, you can press the
green
button to show all Power Link sockets.
Important! If you select
Line
as speaker type in the
Speaker connections
list, the volume
will be very loud and you cannot adjust volume with your BeoRemote One. You must use
the product’s own remote control.
Line
is used for, for example, non-Bang & Olufsen
amplifiers.
Wireless speakers
If you have wireless speakers in your setup, the television automatically scans for wireless
speakers and associate the detected speakers with wireless Power Link channels during
first-time setup. However, you can also scan for wireless speakers and associate the
detected speakers with the television’s wireless Power Link channels manually if you
press
, select
Scan for wireless speakers
and follow on-screen instructions.
You can also access a more advanced scanning function described in this chapter if you
press
, select
Settings
, then
Sound
and
Speaker connections
.
Scan for and associate wireless speakers …
1. In the
Speaker connections
menu, press the
red
button to rescan.
2. When the scanning is completed, press the
centre
button to associate the
detected speakers with the television.
46
Summary of Contents for BeoVision Avant-55
Page 1: ......
