Stand settings
Set up the stand
If your television is equipped with the optional motorised floor stand or wall bracket,
you can turn it using the remote control.
Furthermore, you can set the television to turn automatically to face your favourite
viewing position when you switch it on. It can turn to a different position when you
listen to, for example, a connected radio, and turn away to a standby position when
you switch it off. You can also set up other stand positions for other listening or
viewing positions.
If your television is equipped with the optional motorised table stand, you can set it to
tilt slightly in the Stand adjustment menu, found in the Stand menu, for example, to
avoid disturbing reflections.
Settings
Stand
...
Set a stand position
Set a stand position – introduction
If your television is equipped with a motorised floor stand or wall bracket, choose one
position for start-up and one for standby. You can also preset stand positions of your
own choice, for example, when you sit in an armchair reading or when you sit at the
dining table. Bring up the
Stand positions
menu to store, name or delete a stand position.
You cannot rename or delete the
Start-up
and
Standby
stand positions.
Create a new stand position
In the
Stand positions
menu, set
Start-up
to the position you want your television to turn
to when it is switched on. Set
Standby
to the position you want your television to turn to
when it is switched off. You can also make a new stand position.
1. In the
Stand positions
menu, press the
green
button to make a new stand
position.
2. Use the arrow buttons to move the television to the desired position.
3. Press the
centre
button to save.
To delete an existing stand position, press the
red
button in the menu and follow on-
screen instructions. To rename a stand position, press the
yellow
button and follow on-
screen instructions. The pre-named stand positions can be changed but not renamed or
deleted.
Adjust the stand
If your setup includes a motorised floor stand or wall bracket, you will during first-time
setup be prompted to calibrate the outer positions of the motorised movement. For the
floor stand, this is done by entering the distance from the stand to the wall, follow on-
screen instructions. The motorised movement of the television will not work until the
calibration process has been completed. If the television is placed differently later on, for
example, in a corner, it is necessary to calibrate the motorised movement again. For
information about moving your television press the
red
button in the on-screen help and
23
Summary of Contents for BeoVision Avant-55
Page 1: ......
