Bang & Olufsen BeoCenter 6-23, Reference Book

Page: 36 / 68

36
Connect a decoder
Connect additional video equipment
This chapter describes how to
connect additional video equipment
to the television.
A decoder can be connected to the
television via the AV 2 socket. If your
setup also includes a Bang & Olufsen
video recorder, you should connect
the decoder to the video recorder.
A set-top box can be connected to
any of the AV sockets.
When you connect a Bang & Olufsen
video recorder, you must connect it
to the AV 1 socket, the television
detects the connection automatically.
Make sure that all connected
equipment is registered in the
CONNECTIONS menu. For further
information, refer to the chapter
‘Register additional video equipment’
on page 40.
Disconnect all involved systems from the
mains before you connect external
equipment.
> Connect the cable from the external aerial to
the socket marked TV on the television.
> Connect the decoder to the 21-pin AV 1 socket
on the television’s socket panel.
If you wish to connect an RF decoder, connect the
external aerial cable to the decoder input socket
and then forward the signal or cable to the
television’s aerial socket (marked ‘TV IN’).
Tuned programs and decoder detection
In most cases, a connected decoder is registered
automatically during tuning. The decoder should
automatically detect those programs which
require decoding. However, if this is not the case,
then adjust the setting via the MANUAL TUNING
menu for the program in question. Please refer to
the section entitled
‘Adjust tuned TV programs ’ in
the chapter ‘ Edit tuned programs’ on page 18.
BeoCenter Primary decoder
Secondary decoder