Technical data
Panel PC 2200 built-in devices User's manual V 1.05 Translation of the original documentation
191
Model number
5ACCIF01.FPSC-001
POWERLINK
Quantity
1
Transfer
100BASE-TX
Type
Type 4
2)
Design
RJ45, shielded
Transfer rate
100 Mbit/s
Cable length
Max. 100 m between two stations (segment length)
CAN
Quantity
1
Design
10-pin, male, galvanically isolated
Transfer rate
Max. 1 Mbit/s
Terminating resistor
Type
Can be switched on and off with slide switch
X2X
Type
X2X Link master
Quantity
1
Design
10-pin, male, galvanically isolated
Electrical characteristics
Power consumption
2 W
Operating conditions
Pollution degree per EN 61131-2
Pollution degree 2
Environmental conditions
Temperature
Operation
-20 to 55°C
Storage
-20 to 60°C
Transport
-20 to 60°C
Relative humidity
Operation
5 to 90%, non-condensing
Storage
5 to 95%, non-condensing
Transport
5 to 95%, non-condensing
Mechanical characteristics
Weight
25 g
Table 191: 5ACCIF01.FPSC-001 - Technical data
1)
Yes, but applies only if all components installed in the complete system have this certification and the complete system bears the corresponding mark.
2)
For additional information, see Automation Help (Communication - POWERLINK - General - Hardware - IF / LS).
2.3.5.7.3.1 POWERLINK interface - Pinout
The POWERLINK interface on the system unit is referred to as "IF option".
POWERLINK
1)2)
Wiring
S/STP (Cat 5e)
Cable length
Max. 100 m (min. Cat 5e)
LED "Status"
On
Off
Green
See status/error LED.
LED "Link"
On
Off
Yellow
Link (a connec-
tion to a POWER-
LINK network exists)
Activity (blinks) (data
is being transferred)
RJ45, female
LED "Status"
1
LED "Link"
Table 192: 5ACCIF01.FPSC-001 - POWERLINK interface
1)
The interfaces, etc. available on the device or module have been numbered for the purpose of clear differentiation. This numbering may deviate from the
numbering used by the respective operating system, however.
2)
In Automation Studio / Automation Runtime, this interface is referred to as IF1.
