![background image](http://html1.mh-extra.com/html/bandelin/sonopuls-hd-4050/sonopuls-hd-4050_user-instructions_3768958014.webp)
14 / 48
51376g GB/2018-04
1
electronic GmbH & Co. KG • Heinrichstraße 3-4 • 12207 Berlin • Deutschland • [email protected]
2 Preparation
Carefully unpack the HF generator, ultrasonic transducer and accessories, and inspect them for
completeness or possible transportation damage. If any damage or defects are found, these must
be immediately noti
fi
ed in writing to the transportation company and to the supplier.
Before startup, the ultrasonic homogeniser is to be left to stand at its operating location for 2 hours
so that it may adapt to the ambient conditions.
2.1
Scope of delivery
The scope of delivery will depend on the size of the order. However, it will generally include the
following parts:
1
HF Generator GM .... - see delivery note
1
Ultrasonic transducer UW ...
1
Standard horn SH ...
1
Probe
1 Instructions for Use manual
Additional accessories according to order – see delivery note
2.2
Set-up / assembly
Place the HF generator atop a
fi
rm, level and dry surface. In doing so,
•
do not group it or stack it over other electrical or electronic devices,
•
do not cover the ventilation holes on the ultrasonic transducer's housing,
•
guard against moisture and wetness - risk of electric shock.
During delivery, the standard horn (if required) is already
fi
rmly screwed to the corresponding
ultrasonic transducer.
Other standard horns are mountable. To do so, see instructions in chapter 4.4.
Screw the delivered probe to the standard horn, see chapter 4.3.1.
Position the ultrasonic transducer safely and correctly inside the holder.
To do so, af
fi
x the ultrasonic transducer onto the sound proof box's supporting ring or
fi
rmly
mount the ultrasonic transducer on the black housing alone, using a suitable support, e.g. a
stainless steel stand.
Connect the ultrasonic transducer to the HF generator.
The ultrasonic transducer is connected to the HF generator through a push-pull circular
connector with lock (MINISNAP). To connect, hold the connector from the handle and position
it in such a way that the arrow points upward. The connector can only be plugged in when in
this position. Plug the connector into the socket up to the limit, until it snaps in place. In order
to unplug the connection, hold the connector only from the handle, pull it back and remove the
connector. If necessary, see chapter 1.
Verify that the mains switch is in the "0" position.
Before the mains connection, identify the mains voltage at hand and compare it with the
voltage speci
fi
ed on the type plate on the generator bottom. Connect to a grounded socket
only if type is suitable.
Summary of Contents for Sonopuls HD 4050
Page 44: ......