Bally ProSlot 6000, Setup And Operation

Page: 339 / 444

Peripherals
©2002 Bally Gaming and Systems 8-39
Peripherals
Ticket Printers (cont.)
8. The receipt and journal thread through different paths.
Using the Thumb Wheel ( Gear on the left side. See
bottom figure) to advance the paper, guide the journal
and receipt paper so that they are separated by the
Shear Plate.
9. Advance about six inches of paper then tear off only
the white receipt ply.
10. Reassemble the Journal Takeup Spindle by turning
the flange in the direction of the
ON
arrow. Do not
overtighten.
11. Fold about ½” of the journal paper and insert it into
the groove of the Journal Takeup Spindle so that the
gear is to the right.
12. Turn the Journal Takeup Spindle a few turns in the
direction of the
ON
arrow to take up the excess jour-
nal paper.
Replacing the Printhead
1. Remove the ribbon cassette.
2. Release the printhead by unfastening the Printhead
Clamp. Pull the tab on the left to swing it open.
3. Hold down the Cutter Blade Cover.
4. Pull the printhead free from the edge connecter and
carriage.
5. Using the guide on the printhead, slide the new
printhead onto the carriage and into the edge con-
nector.
Function Switch
The Function Switch is
a momentary two-posi-
tion switch that provides
the following functions:
With power ON:
Left: Incremental paper
advance
Right: Auto paper ad-
vance and cut.
Position switch with
power OFF, then power ON:
Left: Print Test
Right: Hex Data Dump
WARNING: The printhead may be hot.