Balluff Micropulse BTL5-A series, User Manual, Page: 9 / 16

WWW.BALLUFF.COM
•
1-800-543-8390 7
™
BTL5-A/C/E/G__-M____-B/Z-S32/KA__
Micropulse Linear Position Transducer
Analog Output-Rod Style
6 Calibration procedure (cont.)
6.1 Selecting calibration mode
System not running:
Depending on the application use
either Teach-in or manual adjust.
System running:
In special situations the online setting
mode may be used.
6.2 Teach-in
The factory-set null- and endpoints will
be replaced by the new null- and
endpoints. First move the magnet to
the new null position, then to the new
end position, and press the buttons to
accept the corresponding value.
See Section 7: Teach-in mode
1st step: Move magnet to new
null position
1 2
1 2
1 / 2
1
1 2
1 1
1 + 2
1 + 2
1 + 2
2 + 1
2 2
2
6.3 Manual adjust
This method allows you to set a new
start and/or end value. This may be
useful if the magnet can not be
brought to the null or end point of the
transducer.
To do this, the magnet is
brought alternately to the new
start and end position, and the
displayed values are adjusted
by keystroke or pressing the
buttons until the desired values
are reached.
See Section 8: Manual adjust
mode
Fig. 6-1: Calibration device
(shown on transducer)
6.4 Reset
The reset function can be used
to restore the transducer to its
factory default settings.
See Section 9:s Resetting all
values (Reset)
6.5 Online-setting
Setting the start and end values
is done while the system
is running.
See Section 10: Online
setting mode
New end
value
New start
value
Null point
Move magnet to new
desired start position.
Move magnet to new
end position
End
point
before
after
before
after
= Button 2
gray
Teach-in Adjust
Null
point
End
point
Buttons
disabled
Buttons
enabled
Null
point
End
point
= Button 1
blue
Reset
Online-
setting
Null point End point
Buttons
disabled
Buttons
enabled
Online-
setting
1
Fig. 6-4: Manual
adjust procedure
Fig. 6-3: Teach-in procedure
End
value
Accept new
end value
Accept new null value
rising
Null
value
f
alling
before
after
2nd step: Move magnet
to new end position
New stroke 100 %
before
after
2
Z_Analog_122003.pmd 12/11/2003, 3:47 PM 7