Balluff BOS R254K-UUI-RH10-S4, Configuration Manual

Page: 149 / 214

www.balluff.com 41 english
5
Primary Device Functions (continued)
5.4.6 System Commands
All commands are available for LSSC (if a switching mode
that supports two setpoints was selected).
Marked commands are not available for AdSS and also not
for LSSC if a switching mode was selected that does not
support two setpoints.
Command Value Device Action
0x40 (64) Teach Apply – Calculates the
switching point for SP1, SP2.
0x41 (65) Teach SP1 – Determines teach
point 1 for setpoint 1 and calculates
the switching point.
0x42 (66) Teach SP2 – Determines teach
point 1 for setpoint 2 and calculates
the switching point. 1)
0x43 (67) Teach SP1 TP1 – Determines teach
point 1 for setpoint 1
0x44 (68) Teach SP1 TP2 – Determines teach
point 2 for setpoint 1
0x45 (69) Teach SP2 TP1 – Determines teach
point 1 for setpoint 2
1)
0x46 (70) Teach SP2 TP2 – Determines teach
point 2 for setpoint 2
1)
0x47 (71) Teach SP1 Start – Starts dynamic
teach-in for setpoint 1
0x48 (72) Teach SP1 Stop – Stops dynamic
teach-in for setpoint 1 and
calculates the switching point.
0x49 (73) Teach SP2 Start – Starts dynamic
teach-in for setpoint 2
1)
0x4A (74) Teach SP2 Stop – Stops dynamic
teach-in for setpoint 2 and
calculates the switching point.
1)
0x4E (78) Teach Reset – Any active teach-in
process is interrupted, all
temporarily stored values are reset.
0x4F (79) Teach Cancel – Any active teach-in
process is interrupted.
1)
Not available for AdSS. Available for LSSC if the currently set mode
supports 2 setpoints.
Tab. 5-19: Switching profiles – System Commands
For an overview of all System Commands, see section 3.5
on page 25.
5.4.7 Events
Event Code Event Type Description Device Status
0x8DC0 (36288) Notification Teach-in Timeout – The current teach-in process took
too long and was interrupted.
0 – Device is operating properly.
Tab. 5-20: Switching profiles – Events
BOS R254K-UUI-RH10-S4
Photoelectric Sensors