Baldor DG3E, Installation & Operating Manual

Page: 13 / 30

Section 3
Receiving & Installation
Receiving & Installation 3-1 MN2414
Receiving & Inspection
When you receive your generator, there are several things you should do immediately.
1. Observe the condition of the shipping container and report any damage immediately to
the commercial carrier that delivered your system.
2. Verify that the part number of the system you received is the same as the part number
listed on your purchase order.
3. If the system is to be stored for several weeks before use, be sure that it is stored in a
location that conforms to published storage temperature and humidity specifications.
Lifting the Generator
When lift or hoist equipment is used to lift the generator and move it to position, be careful not to
contact overhead wires or other obstacles. The generator weighs between 100 and 350 lbs.
Use proper lift equipment and methods to avoid injury. Lift only by the tubular metal frame.
Figure 3-1 DG Series Generators
Storage If you will not be using the generator set for a significant amount of time (3 months or longer) you
should store the generator to prevent any problems that could arise from sitting idle. Please fully
read the following guidelines prior to storing the unit.
1. Close all the fuel valves.
Note: Do not let the fuel tank run completely empty. Unlike gas engines, diesel engines must be
primed to remove air from the fuel lines.
2. Disconnect and remove the battery if your generator set is so equipped.
3. Drain the used oil from the engine’s crankcase and refill it with clean oil.
4. Provide maintenance to the engine and generator set as described in the engine and
generator maintenance sections of this manual.
5. Cover any bare metal spots with paint or another type of rust preventative.
WARNING: Never store an engine with fuel in its tank indoors or in an enclosed, poorly ventilated area
where diesel fumes could reach an ignition source and cause an explosion.