![background image](http://html1.mh-extra.com/html/balboa-instruments/dolphin/dolphin_manual_3053491016.webp)
31
30
USING THE
LEARNING FEATURE
You can program the non-spa buttons to add
functions that are unique to your home entertainment
devices (e.g., VCR Tracking Up or Down).
NOTE: PLEASE HAVE YOUR ORIGINAL REMOTE
CONTROLS ON HAND BEFORE PROGRAMMING
THE LEARNING FEATURE. BE SURE TO PRESS
EACH KEY WITHIN 10 SECONDS OF THE PREVIOUS
ENTRY. IF 10 SECONDS PASS BETWEEN ENTRIES,
THE REMOTE CONTROL WILL EXIT THE
PROGRAMMING MODE.
Programming A Learning Key
1. Place your original remote control (e.g., TV
remote control) head-to-head (about 2" apart)
from the Dolphin Remote Control.
2. Press and hold SETUP until the LED (red light)
blinks twice, then release SETUP.
3. Enter 9 - 7 - 5. The LED will blink twice.
4. Press a device key once (e.g., TV) to assign a
mode for learning.
5. Press an open learning key once (e.g., Guide)
to store a feature to be learned. The LED will
blink rapidly.
NOTE: THE DOLPHIN LED LIGHT MUST BE BLINKING
IN ORDER TO PROGRAM. IF AT ANY TIME DURING
PROGRAMMING, THE DOLPHIN LED STOPS
BLINKING, GO BACK TO STEP 1 AND START AGAIN.
6. On your original remote control, press and hold
the key feature to be learned until the LED on the
Dolphin Remote Control blinks twice. If the LED
does not blink twice, repeat steps 3 through 6.
7. To learn functions onto other learning keys,
repeat steps 3 through 6.
8. To exit learning mode, press and hold SETUP
until the LED blinks twice, then release SETUP or
wait 10 seconds.
9. To test a learned feature, press a device key
(e.g., TV) once where the learning mode was
assigned. Then press the learning key (e.g., Guide)
where the learned feature is stored.
Deleting Functions From The Learning Keys:
1. Press and hold SETUP until the LED (red light)
blinks twice, then release SETUP.
2. Enter 9 - 7 - 6. The LED will blink twice.
3. Press the device key once where the learned
feature is stored (e.g., TV).
4. Press the learning key (e.g., Guide) twice. The
LED will blink twice after the second press.
5. To clear additional functions stored on
other learning keys, repeat steps 1 through 4
(in this section).
Original Remote
Point the original
remote toward the
LED bump that is
marked with a dot
in front of it.
Feature Reset
This function will clear all volume lock and learned
key functions. It does not clear device codes and
mode reassignments.
1. On the Dolphin, press and hold SETUP until the
LED (red light) blinks twice, then release SETUP.
2. Enter 9 - 8 - 0. The LED will blink 4 times when
reset is complete..
NOTE: LEARNING SHOULD BE DONE INDOORS AND
AWAY FROM FLUORESCENT LIGHTS.