26 |
© 2021 Baker Hughes Company. All rights reserved.
Mounting the SVi1000 on Reciprocating Valves
This section describes the procedure for mounting the SVi1000 on Reciprocating Valves, using
Masoneilan’s 87⁄88 Multi-Spring actuators as an example. Figure 13 on page 26 shows the
standard lever for all size installations. See
Integrated Magnet Assembly
on page 29 for the
optional IM assembly.
Tools required:
o
7⁄16” Combination Wrench (2 required)
o
3⁄8” Combination Wrench
o
1⁄2” Combination Wrench
o
Phillips Head Screw Driver
o
M4 Hex Key
o
M3 Hex Key
1.
Mount the standard reciprocating mounting bracket to the valve using two (2) 5⁄16 - 18 UNC
cap screws.
Figure 12 - Reciprocating Valve Mounting Bracket for Standard Lever
2.
Ensure that the lever is pinned to the magnet assembly and held securely by an M5 flat
head screw to ensure that the magnet axis is vertical when the lever is in the valve closed
position. Tighten the lever screw securely (Figure 13).
Figure 13 - Magnet Holder and Standard Lever for Reciprocating Valves
MS Flat head screw to
install lever
C
D
A
B
