INSTALLATION
SETUP/PHYSICAL INSTALLATION
I-E96-411A
2 - 7
3. Connect an 18 AWG wire from the 24 VDC bus of the termi-
nation mounting unit to the +24 VDC terminal of the IDO mod-
ule.
4. Connect an 18 AWG wire from the common bus of the ter-
mination mounting unit to the common terminal of the IDO
module.
5. Insert the IDO module until it locks securely into place.
6. Replace (snap on) the front cover.
The NIDO01 module is ready for operation if:
1. The fuse is installed.
2. The jumpers are configured for the type of master or slave
module used.
3. All required cables are installed and verified.
4. If required, power is connected and applied to the IDO
module.
