INSTALLATION
INSTALLING THE MODULE
3 - 10
WBPEEUI230019A0
®
Before installing the MFP module:
1. Check all module dipswitch and jumper settings (normal
and special operation)
2. Insure that respective module cables are attached to their
proper slot in the module mounting unit backplane.
To install the MFP module:
1. Guide the top and bottom edges of the module along the
top and bottom rails of their assigned slot in the module
mounting unit.
2. Push on the faceplate until the rear edge of the module is
firmly seated in the backplane connectors.
NOTE: If installing the MFP module under power, verify the status
LED illuminates red momentarily and then illuminates green. If these
events do not occur, refer to
for corrective action.
3. Turn the two latching screws 1/2 turn to lock the module
in place. The module is locked in place when the open end of
the slots on the latching screws face the center of the faceplate.
CAUTION
To avoid potential module damage, evaluate your system for
compatibility prior to module installation. This module uses
connections to the module mounting unit backplane that
served other functions in early Network 90 systems.
