INSTALLATION
PERIPHERALS
WBPEEUI220754A0
3 - 35
Set the SCSI address on the SCSI address switch located on
the back of the tape drive case next to the power and cable con-
nections. Refer to Table
NOTE: The tape drive must be powered down and then up for new
switch settings to take effect.
To install a digital audio tape drive, follow these steps:
1. Insure that the power to both the tape drive and the OIS is
OFF.
2. For consoles, the IIDMT03 is used as a tabletop unit.
Attach the external SCSI cable (Table
), one end to the tape
drive SCSI port and the other end to the peripheral port on the
power entry panel.
3. For driver cabinets, remove the cover plate from the front of
the power entry panel. The power entry panel has a support
tray that enables mounting the IIDMT03A into the rack.
Remove the hook velcro strip from the support tray: the loop
strip will remain on the tray. Remove the adhesive backing
from the strip of velcro and apply the strip to the underside of
the tape drive. Position the tape drive in the tray. There is an
internal SCSI cable with multiple connectors in the driver cabi-
net (Fig.
). Connect as shown.
4. Connect the supplied power cable from the tape drive to a
local power source.
5. Verify that the green LED is ON.
6. Apply power to the OIS.
IIDOP04A and IIDOP05A Optical Disk Drive
Two optical disk archiving units are available. The console uses
the tabletop IIDOP04A optical disk. The driver cabinet uses the
rack mounted IIDOP05A optical disk. If an additional
IIDOP05A is required, order part number 1949017
_
1 and
1947950
_
2 (power cord) to receive the optical disk unit without
duplicate mounting brackets and hardware.
The RWZ52 optical disk drive is a SCSI compatible storage
device that reads and writes to removable disks. Next to the
button is the emergency eject hole for removing disks
without power. An eject tool is provided with the unit.
NOTE: The OIS42 only supports the rewritable media format at
1,024 bytes per sector.
EJECT
