COMPONENT DESCRIPTION AND REPLACEMENT
OPERATOR INTERFACE DEVICES
6 - 24
WBPEEUI220754A0
®
5. Remove all of the cables from the rear of the keyboard
interface panel and floppy disk drive unit.
6. Remove the two screws holding the bottom on the keyboard
interface panel to the rear side of the monitor bezel. There are
no screws on top or on the sides of the panel.
7. Carefully remove the keyboard interface panel containing
the floppy disk drive out of the cabinet.
8. Verify that the floppy disk drive signal and power cables are
moved and labeled.
Floppy Disk Drives
The floppy disk drive can be removed from the cabinet with or
without out removing the keyboard interface panel. To remove
the floppy disk drive and keyboard interface panel from the
console, refer to the
remove the floppy disk drive without removing the keyboard
interface panel refer to Figure
and follow these steps:
1. Turn off the main circuit breaker on the power entry panel
to shut off power to the console. Verify power is removed.
2. Lift the tab in the bottom center of the floppy disk drive
mounting bracket until it stops (approximately 5.0 mm [0.2 in.]).
3. Slide the floppy disk drive out until the cables can be
unplugged. Pull carefully, if the drive does not slide easily, one
of the signal cables may be tangled.
4. Unplug the cables from the back of the floppy disk drive.
5. Slide the floppy disk drive out. Remove the drive carefully.
Color Monitor
Resolution for the OIS high resolution color monitor is 1280 x
1024 pixels. Adding additional color monitors is model depen-
dent.
Refer to Table
for the monitor part number. Refer to
Figure
and refer to Table
for the OIS console monitor
cable connections.
1. Plug the monitor cable into the monitor port on the back of
the CPU.
2. Connect the red, green and blue cable plugs to the corre-
sponding connectors on the back of the monitor. Use only sup-
plied cables because of length limitations.
3. Plug the monitor power line into the proper socket on the
back of the CPU.
